Car steering ball joint is on all the key components of the car will be used, and some even exposed to rain, muddy conditions. Thus, the steering ball joints of the car performance and durability testing is necessary. BANG Instrument Co., Ltd. produces car steering ball joint seal testing machine, and reference to various detection methods and standards. Reference to the following testing methods：

1. 【Steering Rod Assembly Technical Requirement for IVECO】

2. NJ18.3015.90 【steering rod ball joint assembly technical conditions for IVECO】

3. SAEJ193.FEB87 【Ball Stud and Socket Assembly-Test Procedures】

4. JASO. C715 【EN-Bench Test Procedures of Steering Ball Joint for Rack and Pinion Type】 

5. JASO.C615 【EN-Bench Performance Test Procedure for Steering Shaft Joint】 

BANG Instrument Co. produced car steering ball joint seal testing machine, the level can be carried out at room temperature and water spray endurance test Winnipeg, swinging and rotating the durability test, etc., and may be set for the frequency of oscillation, the oscillation angle, and the rotation angle of the rotation frequency. Temperature ranges -40 ℃ to 85 ℃, the maximum test load capacity test bench for 50Nm, to meet the needs of different tests. Testing process in a variety of data can be archived, and can automatically generate test reports, report formats can edit their own testing equipment Also with this section are: automatic fault diagnosis function, when an exception occurs during the test, the device will automatically stop testing and record failure information.